virtual-private-cloud/umn/source/security/firewall/adding_a_firewall_rule.rst

original_name

en-us_topic_0051746702.html

Adding a Firewall Rule

Scenarios

Add an inbound or outbound rule based on your network security requirements.

Procedure

1. Log in to the management console.

2. Click in the upper left corner and select the desired region and project.

3. Click in the upper left corner and choose Network > Virtual Private Cloud.

4. In the navigation pane on the left, choose Access Control > Firewalls.

5. Locate the target firewall and click its name to switch to the page showing details of that particular firewall.

6. On the Inbound Rules or Outbound Rules tab, click Add Rule to add an inbound or outbound rule.

   • Click + to add more rules.
   • Locate the row that contains the firewall rule and click Replicate in the Operation column to replicate an existing rule.

   

   Figure 1 Add Inbound Rule

   Table 1 Parameter descriptions

   Parameter	Description	Example Value
   Priority	Priority of firewall rule. A smaller priority value represents a higher priority. Each network ACL includes a default rule whose priority value is an asterisk (*). Default rules have the lowest priority.	3
   Status	Status of a firewall. When you add a rule to it, its default status is Enabled.	Enabled
   Action	The action in the firewall. This parameter is mandatory. You can select a value from the drop-down list. Currently, the value can be Allow or Deny.	Allow
   Protocol	The protocol supported by the firewall. This parameter is mandatory. You can select a value from the drop-down list. The value can be TCP, UDP, All, or ICMP. If ICMP or All is selected, you do not need to specify port information.	TCP
   Source	The source from which the traffic is allowed. The source can be an IP address or IP address range. IP address: Single IP address: 192.168.10.10/32 All IP addresses: 0.0.0.0/0 IP address range: 192.168.1.0/24 Security group: sg-A	0.0.0.0/0
   Source Port Range	The source port number or port number range. The value ranges from 1 to 65535. For a port number range, enter two port numbers connected by a hyphen (-). For example, 1-100. You must specify this parameter if TCP or UDP is selected for Protocol.	22, or 22-30
   Destination	The destination to which the traffic is allowed. The destination can be an IP address or IP address range. IP address: Single IP address: 192.168.10.10/32 All IP addresses: 0.0.0.0/0 IP address range: 192.168.1.0/24 Security group: sg-A	0.0.0.0/0
   Destination Port Range	The destination port number or port number range. The value ranges from 1 to 65535. For a port number range, enter two port numbers connected by a hyphen (-). For example, 1-100. You must specify this parameter if TCP or UDP is selected for Protocol.	22, or 22-30
   Description	Supplementary information about the firewall rule. This parameter is optional. The description can contain a maximum of 255 characters and cannot contain angle brackets (< or >).	N/A

7. Click OK.