Managing Tags of a VPC Endpoint

Scenarios

After a VPC endpoint is created, you can view its tags, or add, edit, or delete a tag.

Each VPC endpoint has a unique tag, which consists of a tag key and a tag value. You can add a maximum of 20 tags to each VPC endpoint.

If a predefined tag has been created on TMS, you can directly select the corresponding tag key and value.

For details about predefined tags, see Predefined Tag Overview.

Add a Tag

Perform the following operations to add a tag for an existing VPC endpoint:

1. Log in to the management console.
2. Click in the upper left corner and select the required region and project.

3. Choose Service List > Networking > VPC Endpoint.

4. In the VPC endpoint list, locate the target VPC endpoint and click its ID.

5. On the displayed page, select the Tags tab.
6. Click Add Tag.
7. In the displayed dialog box, enter a key and a value.
   Table 1 describes the required parameters.

   Table 1 Tag requirements for VPC endpoints

   Parameter	Requirement
   Tag key	Cannot be left blank. Must be unique for each resource. Can contain a maximum of 36 Unicode characters. Can contain only letters, digits, hyphens (-), and underscores (_).
   Tag value	Cannot be left blank. Can contain a maximum of 43 Unicode characters. Can contain only letters, digits, hyphens (-), and underscores (_).

8. Click OK.

Edit a Tag

Perform the following operations to edit a tag of a VPC endpoint:

1. Log in to the management console.
2. Click in the upper left corner and select the required region and project.

3. Choose Service List > Networking > VPC Endpoint.

4. In the VPC endpoint list, locate the target VPC endpoint and click its ID.

5. On the displayed page, select the Tags tab.
6. In the tag list, locate the target tag and click Edit in the Operation column.
7. Enter a new value.
   

   You can only edit tags that have values.

8. Click OK.

Delete a Tag

Perform the following operations to delete a tag of a VPC endpoint:

Deleted tags cannot be recovered. Exercise caution when performing this operation.

1. Log in to the management console.
2. Click in the upper left corner and select the required region and project.

3. Choose Service List > Networking > VPC Endpoint.

4. In the VPC endpoint list, locate the target VPC endpoint and click its ID.

5. On the displayed page, select the Tags tab.

6. In the tag list, locate the target tag and click Delete in the Operation column.
7. Click Yes.