Configuring Syslog Northbound Parameters

Scenario

If users need to view alarms and events of a cluster on the unified alarm reporting platform, you can use the Syslog protocol on FusionInsight Manager to report related data to the alarm platform.

Procedure

1. Log in to FusionInsight Manager.
2. Choose System > Interconnection > Syslog.
3. Toggle on Syslog Service.

   The Syslog service is disabled by default. indicates that the service is enabled.

4. Set northbound parameters according to Table 1.

   Table 1 Syslog interconnection parameters

   Parameter Area	Parameter	Description
   Syslog Protocol	Server IP Address Mode	Specifies the IP address mode of the interconnected server. The value can be IPV4 or IPV6.
   	Server IP Address	Specifies the IP address of the interconnected server.
   	Server Port	Specifies the port number for interconnection.
   	Protocol	Specifies the protocol type. The options are as follows: TCP UDP
   	Severity Level	Specifies the severity of the reported message. The options are as follows: Emergency Alert Critical Error Warning Notice Informational (default value) Debug NOTE: Severity Level and Facility determine the priority of the sent message. Priority = Facility × 8 + Severity Level For details about the values of Severity Level and Facility, see Table 2.
   	Facility	Specifies the module where the log is generated. For details about the available values of this parameter, see Table 2. Default value local use 0 (local0) is recommended.
   	Identifier	Specifies the product ID. The default value is FusionInsight Manager. The identifier can contain a maximum of 256 characters, including letters, digits, underscores (_), periods (.), hyphens (-), spaces, and the following special characters: | $ { }
   Report Message	Report Format	Specifies the message format of the alarm report. For details, see the help information on the page. The report format can contain a maximum of 1024 characters, including letters, digits, underscores (_), periods (.), hyphens (-), spaces, and the following special characters: | $ { } NOTE: For details about each field in the report format, see Table 3.
   	Alarm Type	Specifies the type of the alarm to be reported.
   	Alarm Severities	Specifies the level of the alarm to be reported.
   Uncleared Alarm Reporting	Periodic Uncleared Alarm Reporting	Specifies whether to report uncleared alarms in a specified period. You can toggle on or off the function. The function is toggled off by default.
   	Report Interval (min)	Specifies the interval for periodically reporting uncleared alarms. This parameter is valid only when Periodic Uncleared Alarm Reporting is enabled. The default value is 15, in minutes. The value ranges from 5 to 1440 (one day).
   Heartbeat Settings	Heartbeat Reporting	Specifies whether to periodically report Syslog heartbeat messages. You can toggle on or off the function. The function is toggled off by default.
   	Heartbeat Interval (minutes)	Specifies the interval for periodically reporting heartbeat messages. This parameter is valid only when Heartbeat Reporting is enabled. The default value is 15, in minutes. The value ranges from 1 to 60.
   	Heartbeat Packet	Specifies the heartbeat message to be reported. This parameter is valid when Heartbeat Reporting is toggled on and cannot be left blank. The value can contain a maximum of 256 characters, including digits, letters, underscores (_), vertical bars (|), colons (:), spaces, commas (,), and periods (.).

   

   After the periodic heartbeat packet function is enabled, packets may be interrupted during automatic recovery of some cluster error tolerance (for example, active/standby OMS switchover). In this case, wait for automatic recovery.

5. Click OK.

Related Information