Installing a Windows OS and the VMTools Driver

Scenarios

This section uses Windows Server 2008 R2 64-bit as an example to describe how to install Windows on an ECS.

The installation procedure varies depending on the image file you use. Perform operations as prompted.

Set the time zone, KMS address, patch server, input method, and language based on service requirements.

Prerequisites

You have remotely logged in to the ECS and entered the installation page.

Procedure

Do not stop or restart the ECS during the OS installation. Otherwise, the OS installation will fail.

1. Install the Windows OS.
   1. Specify the parameters on the Install Windows page.
      Figure 1 Install Windows
      
   2. Click Next.

      The installation confirmation window is displayed.

      Figure 2 Installation confirmation window
      
   3. Click Install now.

      The Select the operating system you want to install window is displayed.

      Figure 3 Selecting the OS version
      
   4. Select the version of the OS to be installed and click Next.

      The Please read the license terms window is displayed.

      Figure 4 License terms window
      
   5. Select I accept the license terms, and click Next.

      The Which type of installation do you want? window is displayed.

      Figure 5 Installation type
      
   6. Select Custom (advanced).

      The Where do you want to install Windows? window is displayed.

      • If the system displays a message indicating that no driver is found, go to 1.g.
        Figure 6 Installation path
        
      • If a disk is displayed, go to 1.j.
        Figure 7 Installation path
        
   7. Click Load Driver and then Browse.
      Figure 8 Loading drivers
      
   8. Choose the following path and click OK.

      vmtools-windows/upgrade/$OS_Version/drivers/viostor

   9. Select the driver matching the OS and click Next.

      The system may provide multiple drivers. Select VISOTOR.INF shown in the following figure.

      Figure 9 Selecting the driver to install
      
   10. Select the disk and click Next.
       Figure 10 Installation path
       
       

       If the disk type is Offline, you can stop and then start the ECS, and restart the OS installation process.

       Figure 11 Offline disk
       
   11. The Installing Windows window is displayed, and the OS installation starts.

       The installation takes about 50 minutes. The ECS restarts during the installation. After the ECS successfully restarts, log in to it again and configure the OS as prompted.

       

       You are required to set a password for the OS user.

       Supported special characters include !@$%^-_=+[{}]:,./?

       Figure 12 Installation progress
       

2. Install related drivers.
   1. Open Computer and double-click the CD driver.
      Figure 13 Starting the CD driver
      
   2. Double-click the vmtools-windows folder.
      Figure 14 Opening the vmtools-windows folder
      
   3. Double-click the Setup file.
      Figure 15 Executing the Setup file
      
   4. Install drivers as prompted.
      Figure 16 Installing UVP VMTools for Windows
      
   5. After the driver is installed, start Device Manager and verify that the drivers shown in the red box in the following figure are successfully installed.
      Figure 17 Device Manager